Page 1 of 1

Metalcloak Skid Plates

Posted: Sat Dec 11, 2021 1:56 pm
by Gso125
For the people that have the Metalcloak full undercloak skid plates do you have any issues with them due to mud and snow. Looks like it’s going to be a pain flushing them out. Got the motor and transmission skid on noticed it’s going to trap all the crap.

Re: Metalcloak Skid Plates

Posted: Sat Dec 11, 2021 4:45 pm
by beaker
Just put the on the JKU last month, I'll let you know how it goes....

Re: Metalcloak Skid Plates

Posted: Sat Dec 11, 2021 10:08 pm
by RandyCarol
Probably, haven’t looked in there yet

Re: Metalcloak Skid Plates

Posted: Sun Dec 12, 2021 8:17 pm
by bangel2209
I have full Metal cloak skids. I park in a garage, so all the snow melts. As for the mud, its get everywhere. It does take a little while to rinse out, but it must be about the same as other full skids.

Re: Metalcloak Skid Plates

Posted: Tue Dec 21, 2021 7:38 pm
by shrinkhead
great question. this will be my first winter with full belly skids. snow not too worried about but mud could be interesting!!! at the same time it should protect a little against all the salt on the road

Re: Metalcloak Skid Plates

Posted: Wed Dec 22, 2021 8:28 pm
by TheDirector
I have the rock hard 4x4 full belly skid and I know its full of crap in there, and after I splash through a puddle it leaks for a long time afterwards hehe. On mine there is only one small spot to even think about trying to flush it out without laying on the ground.

Re: Metalcloak Skid Plates

Posted: Wed Jan 19, 2022 6:23 pm
by mikepa
Have had a full set of MC skids, including FAD and diffs for two years now. The benefits of their protection to me far outweigh the extra rinse time I give them after wheeling in the mud. That said, I do not see much left over fill on top of my plates

Admittedly, I power wash my rig off and touch up scratches after most trips. And as some would say, it looks too clean when I show up for a run anyway.

Mikep

Re: Metalcloak Skid Plates

Posted: Thu Jan 20, 2022 5:36 pm
by ChrisL
I think any skidplate is going to trap mud and snow, it is the nature of the beast.

I don't think the metalcloak is any better or worse in this regard.

Chris

Re: Metalcloak Skid Plates

Posted: Wed May 15, 2024 9:55 am
by BRWhelan
I have them on my 2door. They definitely hold mud. After a good wheeling, I’ll run the hose down them, just like I do with the rest of the vehicle. No real issues.

Re: Metalcloak Skid Plates

Posted: Wed May 15, 2024 11:54 am
by BlackKnight
I was looking at the Metal Cloak but went with the EVO (most of my rig has EVO parts)